1. Are fans operating ? MORE INFO...

YES NO

2. Can you see any ice forming on the cold side (On the coil)?

YES NO

3. Is the temperature of the surrounding area over 80 °F (25 °C) or over 70% Relative Humidity? MORE INFO...

YES NO

4. Is the unit placed in, or is it venting to an unventilated area, like a garage, attic, unfinished basement, laundry room, closet, etc.?

YES NO

5. Is airflow to and from the cooling unit blocked or obstructed in any way?

YES NO

6. Are any exterior surfaces of the cabinet exposed to sunlight? (for cabinets only)

YES NO

7. Does the door seal tightly when closed?

YES NO

8. Did you properly assemble the cabinet with all joints airtight (Rubber Insulation Cord), or did you build your cellar following our instructions(insulation, vapor barrier,floor, door) ?

YES NO

9. Is the storage temperature properly set at 57° F (14°C)?(or warmer)

YES NO

10. Have you periodically vacuumed the condenser coil?

YES NO

11. Is your unit in “Alarm” mode?

YES NO

12.Is the correct temperature displayed? Does the LED temperature reading appear to roughly correspond with the temperature in the cellar? In case the temperature displayed by the controller does not correspond exactly with the indication of another probe (you trust), we allow for a +/- 4 ºF calibration.
NOTE: Compare to the liquid temperature only. The temperature varies according to the position of wine bottles in your cellar. MORE INFO...

YES NO

If you have not found a solution to your problem please CLICK HERE .